Open main menu

Changes

SETTINGS/Printer/Custom G-Code/Start G-Code

247 bytes added, 20:37, 1 December 2016
m
{{Slice Settings
|G-Code to be run immediately following the temperature setting commands. Including commands to set temperature in this section will cause them not be generated outside of this section.|*G-Code
Will accept See also: [[Automatic G-Code]] '''NOTE:''' All Custom G-Code is subject to [[G-Code Filtering|filtering rules]].|*[http://reprap.org/wiki/G-code G-Code]*[[Custom_G-Code_Variables|Custom G-Code variables]] All G-Code must be uppercase to function properly.|
=== G-Code ===
In this example, the printer will home (G28) at the beginning of the print.}}
 
== See Also ==
 
*[[Automatic G-Code]]
*[[G-Code Filtering]]