Difference between revisions of "SETTINGS/General/Infill/Advanced/Infill Overlap"
< SETTINGS | General | Infill | Advancedm (MatterHackers moved page Settings/General/Infill/Advanced/Infill Overlap to SETTINGS/General/Infill/Advanced/Infill Overlap) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Migrated|slice-settings/general/infill#infill-overlap}} | ||
{{Slice Settings | {{Slice Settings | ||
Latest revision as of 12:07, 12 September 2018
|
|
Migrating: For MatterControl 2.0 the MatterControl documentation is moving to matterhackers.com/mattercontrol/support/. |
Function
The amount the infill edge will push into the perimeter. Helps ensure the infill is connected to the edge.
Parameters
- millimeters (mm)
Can be zero.
Example(s)
mm
On the right half of this screenshot, the three lines on the left are the perimeters, and the diagonal lines on the right are the infill. The infill overlaps just 0.06 mm, which is usually enough to ensure that the infill will stick to the inside-most perimeter.
